• Home
  • TIPALM005: Temperature and Power Out Warning Light

Power Out and Falling Temperature Warning Light

(0)No Reviews yet
$157.95
QuantityPrice
1 – 9$157.95
10 – 24$150.05
25 – 49$142.16
50 – 74$134.26
75 – 99$130.31
100 +$126.36
SKU: TIPALM005
Light Activates When Below 42°F (6°C)
Light Activates When Power is OUT > 15 min
Battery Powered Flashing Light with magnetic base. Provides visual alert for power loss and falling temperatures. The light will automatically start flashing when a loss of power is detected for more than 15 minutes and /or when the temperature falls below 42°F.
Complete Package Works Right out of the Box

Notable Features

Temperature and Power Out Warming Light. The light will automatically start flashing when a loss of power is detected for greater than 15 minutes and/or when the temperature falls below 42°F.

 

  • Part Number TIPALM005
  • Power Loss Light Tuns ON if no power is detected for greater than 15 minutes
  • Freeze Warning Light Turns ON at 42°F / 6°C
  • Automatically resets at 52°F / 11°C
  • Accuracy ±2°F / 1°C
  • 20 foot Sensor extension cord
  • Battery Power Source:  (2) D Batteries Included
  • Battery Life When the Light is ON:  500 hours / 21 Days (flashing)
  • Batteries should be replaced every season
  • Magnetic Base Mount rated @ 17 lb. Pull
  • Alert Module Dimensions: 2.25" x 3" x 2" (57.15mm x 76.2mm x 50.8mm)
  • Alert Module Operating Temperature: 40 to 100°F (4 to 37°C)
  • (1) FREALM013 Freeze Warn Light
  • (1) SNPACC016 Power Out Alert Module
  • (2) "D" Size Batteries
  • (1) 20 Ft. Extension with Sensor
  • (1) Instruction Manual
  • Expert Technical Support
  • Complete Package Works Right out of the Box
  • Place Light is Window
  • Plug Power-Out Module into Receptacle
  • Place Thermal Switch Over a Chair in Middle of Room
  • Run a simple test to confirm working operation.

IMPORTANT: When you add the batteries the Light will start flashing if the Power Alert is not plugged in.   Plug in the Power Alert and place the sensor in a freezer to test the freezing alarm light. The Light will flash in less than 5 minutes. Remove the sensor from the freezer and warm up with your hands to turn off the light.  Next, unplug the Power Alert and wait a minute or two for the light to flash.  Test complete.  Move to location.  Batteries should be replaced annually or after an Alarm Event.

Ratings & Reviews

No reviews available

Be the first to Write a Review