Temperature Controller with 8 Amp Relay

Panel mount digital thermometer controller with analog voltage output of 1 mV per count, ± 3%, bright red LED display, 1/8 DIN plastic housing, hysteresis is ± 3°C or ± 5°F. Proportional Band-Width control Features manual adjust reset. Cycle time is 20 seconds ± 3 seconds. 115/230V AC operation.

Also available in type K-C°, K-F° and J-C° ( Call )

Temperature Sensing Range
Operating Temperature Range
Temperature Accuracy
Temperature Resolution
Temperature Scale
Max Temp
Type of Sensor
Sensor Wire Length
Sensor Type
Sensor Style
Sensor Dimensions
Probe Length
Sheath Diameter
Sheath Length
Sheath Material
Wire Gauge
Wire Length
Wire Material
Special Limits
Stripped Leads Length
Transition Diameter
Transition Length
Plug Size
Jack Size
Time Constant
Response Time
Number of Measuring Points
Number of Events
Color Change
Number of Sensors
Data Points
Min/ Max Memory
Recording Rate
Sampling Rate
Transmission Rate
Exportable Data
Software Required
Software Type
Network Connectivity
WiFi Network
Dimensions
Weight
Calibration Available
Display
Display Dimensions
Offset
Power
Battery Life
Battery Backup
Location
Adhesive
Adhesive Type
Shelf Life
Storage Conditions
Humidity Range
Humidity Accuracy
Humidity Resolution
IP Rating
Special Notes

• JENCON003 Model 378-JF
• Temperature Range: 0-1000°F
• Accuracy: ±0.5%
• Reset: Manual adjust
• Operating temperature: 0 to 40 °C
• 1° Resolution
• Hysteresis : F models: 10 °F (±5 °F)
• Hysteresis : C models: 6 °C (±3 °C)
• Cycle time: 20 sec.  ± 3 seconds
• Analog output: Un-linearizationed output 1 mV/count, ± 0.3% of sp
• T/C burnout: Up scale
• Output relay: 8A at 115VAC, 4A at 230 VAC, resistive load.
• Power source: 115 VAC, 230 VAC, ± 10% 50/60 hz
• Dimensions: 96 x 48 x 105 mm

• Model 378 Instructions

An accurate 1 mV per display count analog output is provided to interface the Temperature Controller with a recorder, printer and so on. The Temperature Controller uses a bright red LED screen. The Temperature Controllers are a single set point proportional/On-Off controller. The proportional bandwidth is adjustable from On-Off to 100 oC or 100 oF with built-in hysteresis. The cycle time is factory set to 20 second ± 3 seconds. The Temperature Controllers have a front panel manual adjust reset potentiometer. The Temperature Controllers are 1/8 DIN front panel mount inside of a plastic housing. Temperature probe connections are made via spade lug connectors.

• Jenco 378-JF Controller
• Instruction Manual
• Requires Thermocouple Sensor and Power Cord
• Expert Technical Support