Multi Change Paint MC165-2
The MC165-2 Multi-Change Paint is supplied in a 1 liter container and has two color changes. The 1st id from Pink to Blue, the 2nd is from Blue to Grey. These changes of color occur at different temperatures depending on the period of time the paint is exposed to the temperature.
1st temperature change from Mauve/Pink to Blue occurs after;2nd temperature change from Blue to Grey occurs after;
| Type of Sensor: | Thermal Paint |
| Temperature Sensing Range: | 329°F ~ 599°F (165°C ~ 315°C) |
| Weight: | 2.75 lbs. |
| Sold As: | 1 Liter |
| Storage Conditions: | Cool Dry / Can be thinned with Acetone |
| Color Change: | Permanent |
| Data Points: | 165°C & 315°C |
- (1) Liter of Paint
- Typical Delivery 4+ Weeks ARO
• TLCSEN264 MC215-2 Technical Data Sheet
• Estimated highest temperature the paint can be subject to without a color change is 120°C
• 1st Coat touch dry in 15 -50 minutes. Allow a min. of 20 minutes before test
Apply to a blast cleaned and degreased surface; no primer is necessary. Apply one coat, allowing to touch dry for 15-30 minutes. The best thermal mapping is achieved by an even coat of paint. The preferred application method is spraying. The paint may be thinned to spraying viscosity by the further addition of thinners. Removal of the paint can be achieved by using solvents or an abrasive disc.
Q: The technical data sheet lists the coverage area as "6", what unit of measure is this? meters?
A: 6 square metres per litre applied by brush is a good guide
Q: Is there a recommended depth/thickness for a coat of paint?
A: Normally, 60 - 80 microns is a good guide
Q: Can it be recoated over itself?
A: Yes, as long as the surface is pitted / rust-free and cleaned to allow the new coating to adhere fully and smoothly
Q: Is there a preferred "blast profile" that the surface should be to ensure the best coat?
A: Ideally, this should be taken back to clean blasted metal to gain the best results