🚨 Power Out & Freeze Warning Light
This battery-powered flashing warning light provides a highly visible local alert for two critical conditions: extended power loss and falling temperature.
The light automatically begins flashing when power has been out for more than 15 minutes and/or the monitored temperature falls below 42°F (6°C). The temperature alarm automatically resets when conditions rise to 52°F (11°C).
A 20 ft sensor extension cable allows the temperature sensor to be positioned remotely from the warning light. The magnetic base provides quick mounting to compatible metal surfaces, and the complete package arrives ready for use with batteries included.
──────────────────────────
Ideal Applications
❄️ Freeze warning applications
⚡ Power outage notification
🏭 Warehouses and utility areas
🏢 Unattended buildings and facilities
💧 Areas with freeze-sensitive piping
🌡 Temperature-sensitive storage areas
🧪 Laboratories and equipment rooms
🏠 Seasonal and remotely monitored properties
- Part Number TIPALM005
- Power Loss Light Tuns ON if no power is detected for greater than 15 minutes
- Freeze Warning Light Turns ON at 42°F / 6°C
- Automatically resets at 52°F / 11°C
- Accuracy ±2°F / 1°C
- 20 foot Sensor extension cord
- Battery Power Source: (2) D Batteries Included
- Battery Life When the Light is ON: 500 hours / 21 Days (flashing)
- Batteries should be replaced every season
- Magnetic Base Mount rated @ 17 lb. Pull
- Alert Module Dimensions: 2.25" x 3" x 2" (57.15mm x 76.2mm x 50.8mm)
- Alert Module Operating Temperature: 40 to 100°F (4 to 37°C)
- (1) FREALM013 Freeze Warn Light
- (1) SNPACC016 Power Out Alert Module
- (2) "D" Size Batteries
- (1) 20 Ft. Extension with Sensor
- (1) Instruction Manual
- Expert Technical Support
- Complete Package Works Right out of the Box
- Place Light is Window
- Plug Power-Out Module into Receptacle
- Place Thermal Switch Over a Chair in Middle of Room
- Run a simple test to confirm working operation.
- ──────────────────────────
Compliance & Risk Mitigation
- 🚨 Provides immediate visual warning
- ⚡ Identifies extended power interruptions
- ❄️ Warns before conditions approach freezing
- 🔄 Automatic reset prepares for the next event
- 🔋 Independent battery power works during outages
- 📏 Remote sensor supports flexible placement
- 🧲 Magnetic base simplifies installation
- This warning system provides a local visual alert for power loss and falling temperature but should not be used as the sole protective measure where freezing, power interruption, or temperature excursions could create significant safety, property, or product risk. Replace the batteries every season and function-test the power-loss and low-temperature alarms periodically to confirm proper operation.
IMPORTANT: When you add the batteries the Light will start flashing if the Power Alert is not plugged in. Plug in the Power Alert and place the sensor in a freezer to test the freezing alarm light. The Light will flash in less than 5 minutes. Remove the sensor from the freezer and warm up with your hands to turn off the light. Next, unplug the Power Alert and wait a minute or two for the light to flash. Test complete. Move to location. Batteries should be replaced annually or after an Alarm Event.